HP 10500 Series Configuration Manual page 293

4. Configure Switch B:
# Enable STP.
[SwitchB] stp enable
# Configure manual-mode MFF.
[SwitchB] vlan 100
[SwitchB-vlan-100] mac-forced-forwarding default-gateway 10.1.1.100
# Specify the IP address of the server.
[SwitchB-vlan-100] mac-forced-forwarding server 10.1.1.200
# Enable ARP snooping.
[SwitchB-vlan-100] arp-snooping enable
[SwitchB-vlan-100] quit
# Configure GigabitEthernet 1/0/4 and GigabitEthernet 1/0/6 as network ports.
[SwitchB] interface gigabitethernet 1/0/4
[SwitchB-GigabitEthernet1/0/4] mac-forced-forwarding network-port
[SwitchB-GigabitEthernet1/0/4] quit
[SwitchB] interface gigabitethernet 1/0/6
[SwitchB-GigabitEthernet1/0/6] mac-forced-forwarding network-port
5. Enable STP on Switch C.
<SwitchC> system-view
[SwitchC] stp enable
283