HP 10500 Series Configuration Manual page 153
Security configuration guide
Hide thumbs
Also See for 10500 Series:
- Security configuration manual (596 pages) ,
- Configuration manual (512 pages) ,
- Specifications (42 pages)
Table of Contents
Advertisement
Figure 55 Network diagram
Before configuring direct portal authentication, complete the following settings:
Configure IP addresses for the host, switch, and servers as shown in
•
can reach each other.
•
Configure the RADIUS server properly to provide authentication and accounting functions for users.
Configuring the portal server (IMC PLAT 5.0)
NOTE:
This example assumes that the portal server runs on IMC PLAT 5.0(E0101) and IMC UAM 5.0(E0101).
1.
Configure the portal server:
a.
Log in to IMC and select the Service tab.
b.
Select User Access Manager > Portal Service Management > Server from the navigation tree to
enter the portal server configuration page, as shown in
c.
Configure the portal server parameters as needed. This example uses the default settings.
d.
Click OK.
Figure
143
Figure 55
and make sure they
56.
Advertisement
Table of Contents
Troubleshooting
