HP 10500 Series Configuration Manual page 308

flash:/startup.cfg exists, overwrite? [Y/N]:y
Validating file. Please wait..........................
Saved the current configuration to mainboard device successfully.
Configuration is saved to device successfully.
[Sysname] quit
# Reboot the switch.
<Sysname> reboot
CAUTION:
After you enable the FIPS mode, be sure to create a local user and its password before you reboot the
switch. Otherwise, you cannot log in to the switch. If you cannot log in to the switch, reboot the switch
without the configuration file (by ignoring or removing the configuration file) so that the switch works in
non-FIPS mode, and then make correct configurations.
Verifying the configuration
After the switch reboots, enter the username (test) and password (AAbbcc1234%). The system prompts
that your first login is successful, and asks you to enter a new password. Enter a new password which has
at least four characters different than the previous one and confirm the password. Then, the system
displays the <Sysname> prompt.
User interface aux0 is available.
Please press ENTER.
Login authentication
Username:test
Password:
Info: First logged in. For security reasons you will need to change your password.
Please enter your new password.
Password:**********
Confirm :**********
Updating user(s) information, please wait...........
<Sysname>
# Display the current FIPS mode. You can see that the FIPS mode is enabled.
<Sysname> display fips status
FIPS mode is enabled
298