Publickey Authentication Enabled Sftp Client Configuration Example - HP 12500 Series Configuration Manual

open 192.168.1.45
Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
b.
Figure 82 SFTP client interface
Publickey authentication enabled SFTP client configuration
example
Network requirements
As shown in
B acts as the SFTP server and uses publickey authentication and the RSA public key algorithm.
Figure 83 Network diagram
Configuration procedure
In the server configuration, the client public key is required. Use the client software to generate RSA key
pairs on the client before configuring the SFTP server.
Configure the SFTP client:
1.
# Create VLAN-interface 2 and assign an IP address to it.
<SwitchA> system-view
[SwitchA] interface vlan-interface 2
[SwitchA-Vlan-interface2] ip address 192.168.0.2 255.255.255.0
[SwitchA-Vlan-interface2] quit
# Generate the RSA key pairs.
Figure 83, you can log in to Switch B through the SFTP client that runs on Switch A. Switch
237