Publickey Authentication Enabled Stelnet Server Configuration Example - HP 12500 Series Configuration Manual

Figure 72 Specifying the host name (or IP address)
Click Open to connect to the server.
c.
If the connection is successfully established, the system asks you to enter the username and
password. After entering the username (client001) and password (aabbcc), you can enter the
command-line interface of the server.
Publickey authentication enabled Stelnet server configuration
example
Network requirements
As shown in
The switch acts as the Stelnet server and uses publickey authentication and the RSA public key algorithm.
Figure 73 Network diagram
Stelent client
192.168.1.56/24
Host
Figure 73, you can log in to the switch through the Stelnet client (SSH2) that runs on the host.
Vlan-int2
192.168.1.40/24
Stelnet server
Switch
225