Batching (T) - Elcometer 224 Operating Instructions Manual

In addition, the number of readings above limit (or below limit as
applicable) statistic is incremented when readings are stored into
memory, the reading is tagged with either the high or low icon as
appropriate. For more information see Batching on page 18.
To switch off a particular limit go to Menu/Set Limits/Set Upper or
Menu/Set Limits/Set Lower and set the limit value to Off using the up
and down soft keys.
The programmed limit values can be displayed on the reading screen
via Display/Statistics/Select Statistics and checking the
appropriate radio button. The maximum number of statistics that can
be displayed on the reading screen at the same time is 8.
If a low limit has been set up, the upper limit value cannot be lower
than the pre-set lower limit.
Individual limits can also be set up for each batch on Model T gauges.
For more information see Batching on page 18.
Gauge Welcome Screen (ST)
Users can adjust the start up screen on their Elcometer 224 gauges
via the ElcoMaster™ 2.0 software - see page 50 for more information.

7 BATCHING (T)

The Elcometer 224 Model T has two measurement modes:
Immediate mode: Where readings are taken, rolling statistics
calculated (and displayed), but individual values are not stored in the
memory; and
Batching: Where readings are stored into memory in batches.
Batches allow the user to collate readings for easier analysis of large
structures or complex assemblies. The Elcometer 224 Model T gauge
can store a total of 150,000 readings in up to 2,500 batches and has
the following batching functions:
Create a new batch; Batch/New Batch
Open an existing batch; Batch/Open Existing Batch
Rename an existing batch; Batch/Edit Batch/Rename Batch
www.elcometer.com
R
18