Compressed Air Supply Source (Compressor) - Roland DWX-50 Setup & Maintenance Manual

About Items to prepare separately

Compressed Air Supply Source (Compressor)

Compressed air is necessary for this machine. You need to prepare a compressor separately.
You also need to prepare an air hose to connect the compressor with the regulator in addition.
WARNING
WARNING
Provide a compressor that meets the following conditions.
 Air pressure: 0.2 to 1.0 MPa
 Contamination of the compressed air by foreign material is undesirable. Use an oil-free
compressor.
 Moist air may cause rust. Use a device equipped with a dryer.
 Stable pressure is required. Select a source that has an adequate tank capacity.
Provide a hose that meets the following conditions.
 Hose outer diameter: 6 mm (polyurethane tube)
6 mm
Important!
Be sure to use the included regulator for compressed air supply of this machine.
30
Chapter 1 Installation and Setup
The pressure of the compressed air must be 1.0 MPa or less.
Exceeding this may cause ruptures or other serious accidents.
Ensure no contamination of the supplied compressed air by any water,
oil, chemicals, or foreign objects.
Components may deteriorate or rupture, or the contaminants may be scattered,
posing a hazard.