Roland DWX-50 Setup & Maintenance Manual page 45


You can connect all the machines of which the setting has been done to the computer by USB cables. At this
point, if you connect the machines with a same ID at the same time, the computer might shut down.
To change the name of the machine which has been set, change the name of the installed
printer (the machine you are using).
Windows 7: From [Start] menu, click [Control Panel]  [Hardware and Sound]  [Devices and
Printers].
Windows Vista: From [Start] menu, click [Control Panel]  [Hardware and Sound]  [Printers].
Windows XP: From [Start] menu, click [Control Panel]  [Printers and Other Hardware]  [Print-
ers and Faxes].
Select the name of driver of the machine (Printer) you are using, and change the name.
Restart VPanel.
The name which has been changed appears on the top window.

When you connect the third and fourth machines, turn off the power of all the machines,
disconnect the USB cables from the computer, and exit "VPanel."

Repeat the above steps
Checking ID
 
to .
Connecting Multiple Units
Right-click (VPanel icon) in the task
tray and select "Exit" to exit VPanel.
Restart VPanel.
After VPanel is restarted, the assigned ID is
enabled, and the machine specified in the top
window is displayed. If the machine name is not
changed, "DWX-50 (Copy 1)" is displayed. (The
third machine is displayed as "DWX-50 (Copy
2).")
To check the ID which has been set, select a ma-
chine to check in top window, click [Settings], and
see [Machine ID] under the [Maintenance] tab.
Select an ID and press [Set ID], and the ID is
changed. Note that the changed ID is enabled
if you restart the machine with this setting.
Chapter 1 Installation and Setup
43