Roland DWX-50 Setup & Maintenance Manual page 51

After operation, detach the dust collection hose on the lower right in front side of the machine, remove the
cover of the dust collection capsule, and vacuum up the cutting waste. Especially around the spindle head,
dust collection capsule, and ATC Magazine, the cutting waste must be cleaned up meticulously. Use a brush
or the like to clean away any remains of cutting waste.
Dust collection hose
When cleaning the cutting waste around the table and the main-clamp, you can use VPanel to move the table
and the main-clamp.
Everytime the movement is completed, the message, "Operation is complete," appears. Click [OK].
When the operation button of the built-in panel of the machine is pressed, the spindle head and table return
to the VIEW position (i.e., the left end in the highest position for the spindle head, and the frontmost position
for the table).
Around the Spindle Head
Every time this button is pressed, movement is done in the order of "Table
backward", "Spindle head right", "Table forward", and "Spindle head left".
Main-clamp turns around at a 180°angle.
Daily Maintenance
Around the ATC Magazine
Cap
After cleaning the area around
the cap, remove the cap and
clean the inside as well.
Tray
The tray can be pull out as
shown in the picture.
Chapter 2 Maintenance 49 49