Roland DWX-50 Setup & Maintenance Manual page 4

Operating Instructions
KEEP GUARDS IN PLACE and in working order.
REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and adjusting
wrenches are removed from tool before turning it on.
KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
DON'T USE IN DANGEROUS ENVIRONMENT.
Don't use power tools in damp or wet locations, or
expose them to rain. Keep work area well lighted.
KEEP CHILDREN AWAY. All visitors should be kept
safe distance from work area.
MAKE WORKSHOP KID PROOF with padlocks,
master switches, or by removing starker keys.
DON'T FORCE TOOL. It will do the job better and
safer at the rate for which it was designed.
USE RIGHT TOOL. Don't force tool or attachment to
do a job for which it was not designed.
USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to
carry the current your product will draw. An under-
sized cord will cause a drop in line voltage resulting in
loss of power and overheating.
WEAR PROPER APPAREL. Do not wear loose cloth-
ing, gloves, neckties, rings, bracelets, or other jewelry
which may get caught in moving parts. Nonslip foot-
wear is recommended. Wear protective hair covering
to contain long hair.
USE SAFETY GLASSES, face or dust mask if cutting
or cleaning operation is dusty. Everyday eyeglasses
only have impact resistant lenses, they are NOT safety
glasses.
SECURE WORK. Use clamps or a vise to hold work
when practical.
DON'T OVERREACH. Keep proper footing and bal-
ance at all times.
MAINTAIN TOOLS WITH CARE. Keep tools sharp
and clean for best and safest performance. Follow in-
structions for lubricating and changing accessories.
DISCONNECT TOOLS before servicing; when
changing accessories, such as blades, bits, cutters, and
the like.
2
REDUCE THE RISK OF UNINTENTIONAL
STARTING. Make sure switch is in off position be-
fore plugging in.
USE RECOMMENDED ACCESSORIES. Consult
the owner's manual for recommended accessories.
The use of improper accessories may cause risk of
injury to persons.
NEVER STAND ON TOOL. Serious injury could
occur if the tool is tipped or if the cutting tool is un-
intentionally contacted.
CHECK DAMAGED PARTS. Before further use of
the tool, a guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function - check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condi-
tions that may affect its operation. A guard or other
part that is damaged should be properly repaired or
replaced.
NEVER LEAVE TOOL RUNNING UNATTENDED.
TURN POWER OFF. Don't leave tool until it comes
to a complete stop.