Preparing for Milling
Preparing a Workpiece (Usable Workpieces)
Workpiece Materials
Zirconia, Wax, PMMA, Composite resin, PEEK, Gypsum
Disk type
(with step)
Pin type
Preparing a Milling Bur (Usable Milling Burs)
The figure below shows the size of usable milling burs.
*The shape of the milling bur is merely an example. Select the milling bur that matches the application. Contact your au-
thorized Roland DG Corporation dealer to purchase milling burs.
Preparing Compressed Air (Setting the Regulator)
WARNING
Loosen
(Increase the
pressure.)
Be sure to configure the regulator to 0.2 MPa or lower. Anything higher may result in a malfunction.
Type
Length: 40 to 55 mm
Turn the air pressure adjustment knob slowly and carefully.
Otherwise, the machine may move suddenly, posing a risk of injury.
Upper knob
(The air pressure
adjustment knob)
Tighten
(Decrease
the pressure.)
Size (Unit: mm)
Step section: 98.5 mm (diameter), 10 mm (height)
Body section: 95 mm (diameter), 60 mm (height max.)
Pin diameter: 6 mm
Pull up on the upper knob (The air pressure
adjustment knob).
Slowly turn the upper knob.
Push down on the upper knob.
When supply of air starts, the air starts to flow
and the pressure drops. When the pressure has
dropped, adjust the regulator to have an appropri-
ate value again. (Air is supplied when the spindle
rotates or when the tool is replaced.)
Recommended Set Pressure
0.05
MPa
Zirconia
Wax
Composite resin
Gypsum
Ø5.9 ±0.02
Shank diameter: Ø4 mm
0.2
MPa
PMMA
PEEK
2. Milling
19