What To Do If; Initialization Is Not Performed Or Initialization Fails; Operations Are Ignored - Roland DWX-50 Setup & Maintenance Manual

What to Do If...

For more information about the error messages that appears on VPanel, go to "Responding to an Error Mes-
sage" in "DWX-50 VPanel Guide (electronic-format)."
 P. 40, "How to View the Online Help,"

Initialization is not performed or initialization fails.

Is a front cover open?
When starting the machine, Make sure that the upper and lower front covers are closed and the COVER LED
is dark. For safety, initialization is not performed when a cover remains open at startup.
Is anything caught on the spindle head or table?
Check whether something has become caught and is impeding initialization.

Operations are ignored.

Is the cable connected?
Connect the cable securely.
 P. 37, "Cable Connections"
Is a front cover open?
This machine restricts some operations when a front cover is open.
Close both the upper and lower front covers, and make sure that the COVER LED is dark.
Is operation paused?
When the PAUSE LED is on, it means that operation is paused. When the machine is paused, cutting stops and
some operations are restricted. Cancel the paused state.
Is a large amount of cutting waste present?
Clean away any cutting waste. Clean the area around the spindle especially carefully.
 P. 48, "Cleaning After Cutting Operation Ends"
Is the driver installed correctly?
If the connection to the computer is not made in the sequence described, the driver may fail to be installed
correctly. Check again to ensure that the connection was made using the correct procedure.
 P. 38, "Installing the Windows-based Driver," p. 56, "Installation is impossible"
Does VPanel recognize the machine?
There is a possibility that the machine is not recognized by VPanel. Check the correct connection method.
 P. 37, "Cable Connections," p. 41, "Connecting Multiple Unit"
54
Chapter 3 Appendix