Default Spanning-Tree Configuration - Cisco 3032 Software Configuration Manual

Chapter 18 Configuring STP
•
•

Default Spanning-Tree Configuration

Table 18-3
Table 18-3 Default Spanning-Tree Configuration
Feature
Enable state
Spanning-tree mode
Switch priority
Spanning-tree port priority (configurable on a per-interface basis)
Spanning-tree port cost (configurable on a per-interface basis)
Spanning-tree VLAN port priority (configurable on a per-VLAN basis)
Spanning-tree VLAN port cost (configurable on a per-VLAN basis)
Spanning-tree timers
Spanning-Tree Configuration Guidelines
Each stack member runs its own spanning tree, and the entire stack appears as a single switch to the rest
of the network.
If more VLANs are defined in the VTP than there are spanning-tree instances, you can enable PVST+
or rapid PVST+ on only 128 VLANs on the switch or each switch stack. The remaining VLANs operate
with spanning tree disabled. However, you can map multiple VLANs to the same spanning-tree instances
by using MSTP. For more information, see
If 128 instances of spanning tree are already in use, you can disable spanning tree on one of the VLANs
and then enable it on the VLAN where you want it to run. Use the no spanning-tree vlan vlan-id global
configuration command to disable spanning tree on a specific VLAN, and use the spanning-tree vlan
vlan-id global configuration command to enable spanning tree on the desired VLAN.
OL-12247-04
Configuring the Switch Priority of a VLAN, page 18-21
Configuring Spanning-Tree Timers, page 18-22
shows the default spanning-tree configuration.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
(optional)
(optional)
Default Setting
Enabled on VLAN 1.
For more information, see the
Spanning-Tree Instances" section on
page 18-10.
PVST+. (Rapid PVST+ and MSTP are
disabled.)
32768.
128.
1000 Mb/s: 4.
100 Mb/s: 19.
10 Mb/s: 100.
128.
1000 Mb/s: 4.
100 Mb/s: 19.
10 Mb/s: 100.
Hello time: 2 seconds.
Forward-delay time: 15 seconds.
Maximum-aging time: 20 seconds.
Transmit hold count: 6 BPDUs
Chapter 19, "Configuring MSTP."
Configuring Spanning-Tree Features
"Supported
18-13