Cisco 3032 Software Configuration Manual page 617

Chapter 24 Configuring IGMP Snooping and MVR
To display IGMP snooping information, use one or more of the privileged EXEC commands in
Table
Table 24-4 Commands for Displaying IGMP Snooping Information
Command
show ip igmp snooping [vlan vlan-id]
show ip igmp snooping groups [count |dynamic
[count] | user [count]]
show ip igmp snooping groups vlan vlan-id
[ip_address | count | dynamic [count] |
user[count]]
show ip igmp snooping mrouter [vlan vlan-id]
show ip igmp snooping querier [vlan vlan-id]
show ip igmp snooping querier [vlan vlan-id]
detail
For more information about the keywords and options in these commands, see the command reference
for this release.
OL-12247-04
24-4.
Purpose
Display the snooping configuration information for all VLANs on the
switch or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
Display multicast table information for the switch or about a specific
parameter:
•
•
•
Display multicast table information for a multicast VLAN or about a
specific parameter for the VLAN:
•
•
•
•
•
Display information on dynamically learned and manually configured
multicast router interfaces.
Note
(Optional) Enter vlan vlan-id to display information for a single VLAN.
Display information about the IP address and receiving port for the
most-recently received IGMP query messages in the VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
Display information about the IP address and receiving port of the
most-recently received IGMP query message in the VLAN and the
configuration and operational state of the IGMP snooping querier in the
VLAN.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
count—Display the total number of entries for the specified
command options instead of the actual entries.
dynamic—Display entries learned through IGMP snooping.
user—Display only the user-configured multicast entries.
vlan-id—The VLAN ID range is 1 to 1001 and 1006 to 4094.
count—Display the total number of entries for the specified
command options instead of the actual entries.
dynamic—Display entries learned through IGMP snooping.
ip_address—Display characteristics of the multicast group with the
specified group IP address.
user—Display only the user-configured multicast entries.
When you enable IGMP snooping, the switch automatically
learns the interface to which a multicast router is connected.
These are dynamically learned interfaces.
Displaying IGMP Snooping Information
24-17