Assigning Stack Member Information - Cisco 3032 Software Configuration Manual

Configuring the Switch Stack
This example shows how to configure the persistent MAC address feature for a 7-minute time delay and
to verify the configuration:
Switch(config)# stack-mac persistent timer 7
WARNING: The stack continues to use the base MAC of the old Master
WARNING: as the stack MAC after a master switchover until the MAC
WARNING: persistency timer expires. During this time the Network
WARNING: Administrators must make sure that the old stack-mac does
WARNING: not appear elsewhere in this network domain. If it does,
WARNING: user traffic may be blackholed.
Switch(config)# end
Switch# show switch
Switch/Stack Mac Address : 0016.4727.a900
Mac persistency wait time: 7 mins
Switch#
----------------------------------------------------------
*1

Assigning Stack Member Information

These sections describe how to assign stack member information:
•
•
•
Assigning a Stack Member Number
This task is available only from the stack master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a member number to a stack member.
This procedure is optional.
Command
Step 1
configure terminal
Step 2 switch current-stack-member-number
renumber new-stack-member-number
Step 3
end
Step 4 reload slot stack-member-number
Step 5 show switch
Step 6 copy running-config startup-config
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
5-24
Role Mac Address
Master 0016.4727.a900
Assigning a Stack Member Number, page 5-24
Setting the Stack Member Priority Value, page 5-25
Provisioning a New Member for a Switch Stack, page 5-25
H/W Current
Priority Version
1 0
(optional)
Purpose
Enter global configuration mode.
Specify the current stack member number and the new stack member
number for the stack member. The range is 1 to 9.
You can display the current stack member number by using the show
switch user EXEC command.
Return to privileged EXEC mode.
Reset the stack member.
Verify the stack member number.
Save your entries in the configuration file.
Chapter 5 Managing Switch Stacks
State
Ready
(optional)
(optional)
OL-12247-04