Configuring Vlan Id-Based Mac Authentication - Cisco 3032 Software Configuration Manual

Configuring 802.1x Authentication
Command
Step 12
show ip device tracking all
Step 13 copy running-config startup-config
This example shows how to configure a switch for a downloadable policy:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# aaa new-model
Switch(config)# aaa authorization network default group radius
Switch(config)# ip device tracking
Switch(config)# ip access-list extended default_acl
Switch(config-ext-nacl)# permit ip any any
Switch(config-ext-nacl)# exit
Switch(config)# radius-server vsa send authentication
Switch(config)# int fastEthernet 2/13
Switch(config-if)# ip access-group default_acl in
Switch(config-if)# exit

Configuring VLAN ID-based MAC Authentication

Beginning in privileged EXEC mode, follow these steps:
Command
Step 1 configure terminal
Step 2 mab request format attribute 32 vlan access-vlan
Step 3
copy running-config startup-config
There is no show command to confirm the status of VLAN ID-based MAC authentication. You can use
the debug radius accounting privileged EXEC command to confirm the RADIUS attribute 32. For more
information about this command, see the Cisco IOS Debug Command Reference, Release 12.2 at this
URL:
http://www.cisco.com/en/US/docs/ios/debug/command/reference/db_q1.html#wp1123741
This example shows how to globally enable VLAN ID-based MAC authentication on a switch:
Switch# config terminal
Enter configuration commands, one per line.
Switch(config)# mab request format attribute 32 vlan access-vlan
Switch(config-if)# exit
Configuring Flexible Authentication Ordering
Beginning in privileged EXEC mode, follow these steps:
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
9-62
Chapter 9
Purpose
Displays information about the entries in the IP device tracking table.
(Optional) Saves your entries in the configuration file.
End with CNTL/Z.
Purpose
Enter global configuration mode.
Enable VLAN ID-based MAC authentication.
(Optional) Save your entries in the configuration
file.
End with CNTL/Z.
Configuring IEEE 802.1x Port-Based Authentication
OL-12247-04