Displaying Snmp Status - Cisco 3032 Software Configuration Manual

Displaying SNMP Status

This example shows how to send Entity MIB traps to the host cisco.com. The community string is
restricted. The first line enables the switch to send Entity MIB traps in addition to any traps previously
enabled. The second line specifies the destination of these traps and overwrites any previous
snmp-server host commands for the host cisco.com.
Switch(config)# snmp-server enable traps entity
Switch(config)# snmp-server host cisco.com restricted entity
This example shows how to enable the switch to send all traps to the host myhost.cisco.com using the
community string public:
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com public
This example shows how to associate a user with a remote host and to send auth (authNoPriv)
authentication-level informs when the user enters global configuration mode:
Switch(config)# snmp-server engineID remote 192.180.1.27 00000063000100a1c0b4011b
Switch(config)# snmp-server group authgroup v3 auth
Switch(config)# snmp-server user authuser authgroup remote 192.180.1.27 v3 auth md5
mypassword
Switch(config)# snmp-server user authuser authgroup v3 auth md5 mypassword
Switch(config)# snmp-server host 192.180.1.27 informs version 3 auth authuser config
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server inform retries 0
Displaying SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. You also can use the
other privileged EXEC commands in
the fields in the displays, see the Cisco IOS Configuration Fundamentals Command Reference.
Table 33-6 Commands for Displaying SNMP Information
Feature
show snmp
show snmp engineID [local | remote]
show snmp group
show snmp pending
show snmp sessions
show snmp user
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
33-18
Table 33-6
Default Setting
Displays SNMP statistics.
Displays information on the local SNMP engine and all remote engines that have
been configured on the device.
Displays information on each SNMP group on the network.
Displays information on pending SNMP requests.
Displays information on the current SNMP sessions.
Displays information on each SNMP user name in the SNMP users table.
You must use this command to display SNMPv3 configuration information
Note
for auth | noauth | priv mode. This information is not displayed in the show
running-config output.
to display SNMP information. For information about
Chapter 33 Configuring SNMP
OL-12247-04