Setting The Sdm Template - Cisco 3032 Software Configuration Manual

Chapter 8 Configuring SDM Templates

Setting the SDM Template

Beginning in privileged EXEC mode, follow these steps to use the SDM template to maximize feature
usage:
Command
Step 1 configure terminal
Step 2 sdm prefer {access | default |
dual-ipv4-and-ipv6 {default | routing |
vlan} | routing | vlan}
Step 3 end
Step 4
reload
After the system reboots, you can use the show sdm prefer privileged EXEC command to verify the
new template configuration. If you enter the show sdm prefer command before you enter the reload
privileged EXEC command, the show sdm prefer command shows the template currently in use and the
template that will become active after a reload.
OL-12247-04
Purpose
Enter global configuration mode.
Specify the SDM template to be used on the switch:
The keywords have these meanings:
• access—Maximize system resources for ACLs.
• default—Give balance to all functions.
dual-ipv4-and-ipv6—Select a template that supports both IPv4
•
and IPv6 routing.
default—Balance IPv4 and IPv6 Layer 2 and Layer 3
–
functionality.
– routing—Provide maximum usage for IPv4 and IPv6
routing, including IPv4 policy-based routing.
– vlan—Provide maximum usage for IPv4 and IPv6 VLANs.
• routing—Maximize routing on the switch.
• vlan—Maximize VLAN configuration on the switch with no
routing supported in hardware.
Use the no sdm prefer command to reset the switch to the default
desktop template. The default template balances the use of system
resources.
Return to privileged EXEC mode.
Reload the operating system.
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Configuring the Switch SDM Template
8-5