Configuring An Frspan Session - Cisco 3032 Software Configuration Manual

Configuring FSPAN and FRSPAN
Command
Step 4
monitor session session_number
destination {interface interface-id [, | -]
[encapsulation replicate]}
Step 5
monitor session session_number filter {ip |
ipv6 | mac} access-group
{access-list-number | name}
Step 6
end
Step 7
show monitor [session session_number]
show running-config
Step 8 copy running-config startup-config

Configuring an FRSPAN Session

Beginning in privileged EXEC mode, follow these steps to start an RSPAN source session, specify the
monitored source and the destination RSPAN VLAN, and configure FRSPAN for the session:
Command
Step 1 configure terminal
Step 2
no monitor session {session_number | all |
local | remote}
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
30-26
Purpose
Specify the SPAN session and the destination port (monitoring port).
For session_number, specify the session number entered in Step 3.
For local SPAN, you must use the same session number for
Note
the source and destination interfaces.
For interface-id, specify the destination port. The destination
•
interface must be a physical port; it cannot be an EtherChannel,
and it cannot be a VLAN.
(Optional) [, | -] Specify a series or range of interfaces. Enter a
•
space before and after the comma; enter a space before and after
the hyphen.
(Optional) Enter encapsulation replicate to specify that the
•
destination interface replicates the source interface
encapsulation method. If not selected, the default is to send
packets in native form (untagged).
You can use monitor session session_number destination
Note
command multiple times to configure multiple destination
ports.
Specify the SPAN session, the types of packets to filter, and the
ACLs to use in an FSPAN session.
• For session_number, specify the session number entered in
Step 3.
• For accessl-list-number, specify the ACL number that you want
to use to filter traffic.
• For name, specify the ACL name that you want to use to filter
traffic.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save the configuration in the configuration file.
Purpose
Enter global configuration mode.
Remove any existing RSPAN configuration for the session.
For session_number, the range is 1 to 66.
Specify all to remove all RSPAN sessions, local to remove all local
sessions, or remote to remove all remote SPAN sessions.
Chapter 30 Configuring SPAN and RSPAN
OL-12247-04