Creating Or Modifying An Ethernet Vlan - Cisco 3032 Software Configuration Manual

Configuring Normal-Range VLANs
Table 13-2
Parameter
VLAN ID
VLAN name
IEEE 802.10 SAID
MTU size
Translational bridge 1
Translational bridge 2
VLAN state
Remote SPAN
Private VLANs

Creating or Modifying an Ethernet VLAN

Each Ethernet VLAN in the VLAN database has a unique, 4-digit ID that can be a number from 1 to
1001. VLAN IDs 1002 to 1005 are reserved for Token Ring and FDDI VLANs. To create a normal-range
VLAN to be added to the VLAN database, assign a number and name to the VLAN.
With VTP version 1 and 2, if the switch is in VTP transparent mode, you can assign VLAN IDs greater
Note
than 1006, but they are not added to the VLAN database. See the
VLANs" section on page
For the list of default parameters that are assigned when you add a VLAN, see the
Normal-Range VLANs" section on page
Beginning in privileged EXEC mode, follow these steps to create or modify an Ethernet VLAN:
Command
Step 1 configure terminal
Step 2
vlan vlan-id
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
13-8
Ethernet VLAN Defaults and Ranges
Default
1
VLANxxxx, where xxxx
represents four numeric digits
(including leading zeros) equal
to the VLAN ID number
100001 (100000 plus the
VLAN ID)
1500
0
0
active
disabled
none configured
13-11.
13-4.
Purpose
Enter global configuration mode.
Enter a VLAN ID, and enter VLAN configuration mode. Enter a new
VLAN ID to create a VLAN, or enter an existing VLAN ID to modify
that VLAN.
Note The available VLAN ID range for this command is 1 to 4094.
For information about adding VLAN IDs greater than 1005
(extended-range VLANs), see the
Extended-Range VLANs" section on page
Chapter 13
Range
1 to 4094.
Extended-range VLANs (VLAN
Note
IDs 1006 to 4094) are not saved in
the VLAN database.
No range
1 to 4294967294
1500 to 18190
0 to 1005
0 to 1005
active, suspend
enabled, disabled
2 to 1001, 1006 to 4094.
"Configuring Extended-Range
"Configuring
"Configuring
13-11.
Configuring VLANs
OL-12247-04