Chapter 13
Configuring STP
•
•
•
•
•
•
•
Default Spanning-Tree Configuration
Table 13-3
Table 13-3
Default Spanning-Tree Configuration
Feature
Enable state
Spanning-tree mode
Switch priority
Spanning-tree port priority (configurable on a per-interface basis)
Spanning-tree port cost (configurable on a per-interface basis)
Spanning-tree VLAN port priority (configurable on a per-VLAN basis)
Spanning-tree VLAN port cost (configurable on a per-VLAN basis)
Spanning-tree timers
OL-8915-01
Disabling Spanning Tree, page 13-14
Configuring the Root Switch, page 13-14
Configuring a Secondary Root Switch, page 13-16
Configuring Port Priority, page 13-16
Configuring Path Cost, page 13-18
Configuring the Switch Priority of a VLAN, page 13-19
Configuring Spanning-Tree Timers, page 13-20
shows the default spanning-tree configuration.
(optional)
(optional)
(optional)
(optional)
(optional)
(optional)
Default Setting
Enabled on VLAN 1.
For more information, see the
Spanning-Tree Instances" section on
page
PVST+. (Rapid PVST+ and MSTP are
disabled.)
32768.
128.
1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
128.
1000 Mbps: 4.
100 Mbps: 19.
10 Mbps: 100.
Hello time: 2 seconds.
Forward-delay time: 15 seconds.
Maximum-aging time: 20 seconds.
Transmit hold count: 6 BPDUs
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Configuring Spanning-Tree Features
(optional)
13-9.
"Supported
13-11