Supported Features On The Ethernet Management Port - Cisco 3032 Software Configuration Manual

Chapter 11 Configuring Interface Characteristics
Figure 11-3
1
2
3
By default, the Ethernet management port is enabled. The switch cannot route packets from the Ethernet
management port to a network port and the reverse.

Supported Features on the Ethernet Management Port

The Ethernet management port supports only these features:
•
•
OL-12247-04
Connecting a Switch Stack to a PC
Blade switch
Stack member 1
Blade switch
Blade switch
Stack member 2
Stack member 3
Blade switch
Blade switch
Stack member 4
and stack master
Blade switch
Blade switch
Stack member 5
Stack member 6
Blade switch
Blade switch
Stack member 7
Blade switch
Chassis Management Module
Internal Ethernet management port that are not active because they are not on the stack master
(stack member 4)
Active internal Ethernet management port on the stack master
Note The internal Ethernet management ports on the stack members are disabled.
Express Setup (only in switch stacks)
Network Assistant
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Enclosure 1
3
1
2
2
Enclosure 2
2
1
3
3
2
2
1
3
2
Using the Internal Ethernet Management Port
PC
11-15