Starting Visualdsp - Analog Devices ADSP-21160 EZ-KIT Lite System Manual

Hide thumbs Also See for ADSP-21160 EZ-KIT Lite:

Table of Contents

3. Verify that the USB driver software is installed properly.

Open Windows Device Manager and verify that ADSP-21160

EZ-KIT Lite shows under ADI Development Tools with no excla-

mation point, as in

Figure 1-12. Device Manager Window

If using an EZ-KIT Lite on Windows 98, disconnect the USB

cable from the board before booting the PC. When Windows 98 is

booted and you are logged on, re-connect the USB cable to the

board. The operation should continue normally from this point.

Starting VisualDSP++

To set up a session in VisualDSP++:

1. Verify that the yellow USB monitor LED (

USB connector) is lit. This signifies that the board is communicat-

ing properly with the host PC and is ready to run VisualDSP++.

2. Press and hold down the Control (CTRL) key.

ADSP-21160 EZ-KIT Lite Evaluation System Manual

Figure

1-12.

Getting Started

, located near the

LED5

1-15

Table of Contents

Do you have a question about the ADSP-21160 EZ-KIT Lite and is the answer not in the manual?