Windows Xp Usb Driver - Analog Devices ADSP-21160 EZ-KIT Lite System Manual

Installation Tasks
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, run VisualDSP++ 3.5 installation. Refer to the
VisualDSP++ 3.5 Installation Quick Reference Card for a detailed
installation description. When installing VisualDSP++ 3.5 on
Windows 2000, make sure the appropriate EZ-KIT Lite compo-
nent is selected for the installation.
2. Connect the EZ-KIT Lite device to your PC's USB port.
Windows 2000 automatically detects an EZ-KIT device and auto-
matically installs the appropriate driver for the selected device (see
step 1).
3. Verify the installation by following the instructions in
Driver Installation" on page

Windows XP USB Driver

VisualDSP++ 3.5 installation software pre-installs the necessary drivers for
the selected EZ-KIT Lite. The install also upgrades an older driver if such
is detected in the system.
Prior to running the VisualDSP++ 3.5 installer, ensure there are no
other Hardware Wizard windows running in the background. If
there are any wizard windows running, close them before starting
the installer.
To install the USB driver:
1. If VisualDSP++ 3.5 is already installed on your system, go to
step 2. Otherwise, run VisualDSP++ 3.5 installation. Refer to the
VisualDSP++ 3.5 Installation Quick Reference Card for a detailed
1-12
1-14.
ADSP-21160 EZ-KIT Lite Evaluation System Manual
"Verifying