Starting Visualdsp - Analog Devices ADSP-21262 EZ-KIT Lite Manual

Installation Tasks

Starting VisualDSP++

1-16
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
3. Verify that the USB driver software is installed properly.
Open Windows Device Manager and verify that ADSP-21262
EZ-KIT Lite shows under DSP Emulators with no exclamation
point, as in Figure
Figure 1-12. Device Manager Window
If using an EZ-KIT Lite on Windows 98, disconnect the USB
cable from the board before booting the PC. When Windows 98 is
booted and you are logged on, re-connect the USB cable to the
board. The operation should continue normally from this point.
To set up a session in VisualDSP++:
1. Verify that the yellow USB monitor LED (
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run VisualDSP++.
2. Press and hold down the keyboard Control (CTRL) key.
ADSP-21262 EZ-KIT Lite Evaluation System Manual
1-12.
, located near the
LED11