Creating A Measurement File - Thermo Scientific RadEye B20 Operating Instructions Manual

7.4.3

Creating a Measurement File

The actual measured values Count rate and Dose rate that are
shown in the "Measurement" display field can be stored in a
measurement file.
To do this, open the File menu, click on Open Logfile..., and
enter path and name. The file is stored with the file name exten-
sion ".log".
If another file of the same name exists, the system asks whether
that file shall be overwritten or the new measured data shall be
appended to the existing data.
Once you have pressed OK to confirm the entries, the measure-
ment logfile is created and the polling measured data is stored in
the scan interval you have defined. An open measurement file is
indicated by the name and the path of the measurement logfile
that appears in the top right-hand corner of the window.
To terminate data storage, open the File menu and select the
Close Logfile menu item. No further data is recorded.
Open the File / View Logfile... menu to view the measurement
logfile.
For training and demonstration a prior recorded logfile can be
replayed by opening Replay logfile.
With the buttons Start and Stop together with the polling interval
the replay can be controlled.
Close Replay switches back to accessing measurement values via
infrared interface.
The measurement logfile is an ANSI text file with columns that
are separated by <TAB>. This enables this file to be read easily
into other programs (such as Excel) where the data can be pro-
cessed.
7-6 DB-065 E RadEye B20/-ER
Iw/Tr/Ff 06.03.2017