Creating A Measurement File - Thermo Scientific RadEye SPRD Operating Instructions Manual

8.3.3

Creating a Measurement File

The actual measured values Count rate and Dose rate that are
shown in the "Measurement" display field can be stored in a
measurement file.
To do this, open the File menu, click on Open Logfile..., and
enter path and name. The file is stored with the file name ex-
tension ".log".
If another file of the same name exists, the system asks wheth-
er that file shall be overwritten or the new measured data shall
be appended to the existing data.
Once you have pressed OK to confirm the entries, the meas-
urement logfile is created and the polling measured data is
stored in the scan interval you have defined. An open meas-
urement file is indicated by the name and the path of the mea-
surement logfile that appears in the top right-hand corner of
the window.
To terminate data storage, open the File menu and select the
Close Logfile menu item. No further data is recorded.
Open the File / View Logfile... menu to view the measurement
logfile.
For training and demonstration a prior recorded logfile can be
replayed by opening Replay logfile.
8-6 DB-100 E RadEye SPRD
Pi/Ff 04.11.2014