Advertisement
Identify and remove the inner stern extensions (40) from the 3mm ply sheet, these should be glued into position in the inboard
slots across the after face of bulkhead 9. Ensure the stern extensions are at right angles to the bulkhead and that they run
parallel, that is to say there should be a gap of 6mm between them both at the lowest and uppermost points. Identify and
remove the stern counter (117) from the 0.8mm ply sheet. Soak the counter in water for half an hour then dry fit it centrally
across the curved surfaces of the gunport pattern, inner and outer stern extensions such that the upper edge runs flush with the
change of angle in the stern extensions. With the counter correctly centralised and conforming to the curve against which it is
fitted, the inner stern extensions should not foul the central slot of the counter (Photo 013). The lower edge of the counter
should run flush with the after ends of the first planking, flush with the after face of bulkhead 9 (if not already done, the ends
of the first planking will require trimming to achieve this). When you are happy with the positioning of the counter, it can be
pinned and glued into position (Photo 014).
At this stage you will notice that the stern counter extends beyond the gunport patterns athwartships and also stands proud of
the after end of the first planking by 0.8mm. Gently sand the outboard edges back to the gunport patterns. Temporarily fit the
stern post (27) into position and, using 0.5x4mm walnut, plank the stern counter athwartships, clearing the slot for the rudder
and stern post as you progress ensuring that, where the planks meet the stern post they form a flush fit (Photo 015). Upon
completion, trim the outboard edges of this planking flush to the gunport patterns and remove the stern post. You will also find
that the top edge of the uppermost planks will extend beyond the curved shape of the stern counter; this edge should be
trimmed back while offering the stern facia (77) into position to ensure that they feather
Note: The stern fascia (77) should only be offered into position at this stage, it will not be finally fitted until instructed, after
completion of the second planking.
8
Photo 013
Photo 015
The Stern Counter
©
2006 JoTiKa Ltd.
u
into one another.
Photo 014
Photo 016
Advertisement
