Eigrp Interface Mode Commands - Cisco ONS 15454 Software Feature And Configuration Manual

Configuring IP Routing
Command
Step 5
Router(config)# metric weights tos
k1 k2 k3 k4 k5
Step 6
Router(config)# offset list
[{ access-list-number | name }] { in |
out } offset [ type-number ]
Step 7
Router(config)# no auto-summary
Step 8
Router(config)# ip summary-address
eigrp autonomous-system-number
address-mask
Step 9
Router(config)# end
Step 10
Router# show ip protocols
Step 11
Router# copy running-config
startup-config
Use the no forms of these commands to disable the feature or return the setting to the default value.
This is an example of output from the show ip protocols privileged EXEC command for EIGRP:
Router# show ip protocols
Routing Protocol is "eigrp 1"
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Default networks flagged in outgoing updates
Default networks accepted from incoming updates
EIGRP metric weight K1=1, K2=0, K3=1, K4=0, K5=0
EIGRP maximum hopcount 100
EIGRP maximum metric variance 1
Redistributing: eigrp 1
Automatic network summarization is in effect
Automatic address summarization:
Maximum path: 4
Routing for Networks:
Routing Information Sources:
Distance: internal 90 external 170

EIGRP Interface Mode Commands

Other optional EIGRP parameters can be configured on an interface basis.
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
10-24
192.168.3.0/24 for POS0
192.168.2.0/24 for FastEthernet0
192.168.2.0
192.168.3.0
Gateway Distance
192.168.2.1 90
Chapter 10
Purpose
(Optional) Adjusts the EIGRP metric. Although the defaults
have been carefully determined to provide excellent
operation in most networks, you can adjust them.
Determining metrics is complex and is not
Caution
recommended without guidance from an
experienced network designer.
(Optional) Applies an offset list to routing metrics to increase
incoming and outgoing metrics to routes learned through
EIGRP. You can limit the offset list with an access list or an
interface.
(Optional) Disables automatic summarization of subnet
routes into network-level routes.
(Optional) Configures a summary aggregate.
Returns to privileged EXEC mode.
Verifies your entries.
(Optional) Saves your entries in the configuration file.
Last Update
00:03:16
Configuring Networking Protocols
78-15224-02