Managing Sonet/Sdh Alarms - Cisco ONS 15454 Software Feature And Configuration Manual

Managing SONET/SDH Alarms

POS interfaces are first created when a CTC STS/STM circuit is provisioned.
Note
The port name field configured in CTC and the port name configured in Cisco IOS are independant of
Note
each other. The name for the same port under Cisco IOS and CTC will not match, unless the same name
is used to configure the port name in both CTC and Cisco IOS.

Managing SONET/SDH Alarms

CTC manages the ML-Series SONET/SDH alarm behavior in the same manner as it manages alarm
behavior for other ONS 15454 SONET/SDH cards. Refer to Chapter 7, "Manage Alarms", of the
Cisco ONS 15454 Procedure Guide or Cisco ONS 15454 SDH Procedure Guide for detailed information.
For information on specific alarms, refer to Chapter 2, "Alarm Troubleshooting", of the Cisco ONS
15454 Troubleshooting Guide or Cisco ONS 15454 SDH Troubleshooting Guide for detailed
information.
To view the window, click the Ether Alarming > Provisioning tabs for the Ethernet ports or
POS Alarming > Provisioning tabs for the POS ports.
pane.
Figure 2-5
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
2-8
Managing ML-Series SONET/SDH Alarms
Chapter 2
Figure 2-5 shows the Ethernet ports alarming
CTC Operations
78-15224-02