Using Show Commands To Verify The New Interface Status - Cisco 7304 Installation And Configuration Manual

Chapter 4 Configuring the 6E3 Line Card

Using show Commands to Verify the New Interface Status

Table 4-7 on page 4-9
are configured and operating correctly and that the 6E3 line card appears in them correctly. Sample
displays of the output of selected show commands appear in the sections that follow. For complete
command descriptions and examples, refer to the publications listed in the
section on page
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Table 4-7 Using show Commands
Command
show version
show controllers
show diag slot
show interfaces type slot-number/
interface-port-number
show protocols
show running-config
show startup-config
If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
•
•
•
Choose the subsection appropriate for your system. Proceed to the
Network Connectivity" section on page 4-15
OL-5061-01
demonstrates how you can use the show commands to verify that new interfaces
viii.
Function
Displays system Cisco IOS
software version, names and
sources of configuration files, and
boot images
Displays all the current E3
interfaces
Displays types of line cards
installed in your system and
information about a specific
chassis slot
Displays status information about
a specific type of interface (for
example, serial) in a Cisco 7304
router
Displays protocols configured for
the entire system and for specific
interfaces
Displays the running
configuration file
Displays the configuration stored
in NVRAM
Using the show version Command, page 4-10
Using the show diag (slot) Command, page 4-12
Using the show interfaces Command, page 4-13
Example
Router# show version
Router# show controllers
Router# show diag 2
Router# show interfaces serial 2/0
Router# show protocols
Router# show running-config
Router# show startup-config
when you have finished using the show commands.
Cisco 7304 6-Port Clear Channel E3 Line Card Installation and Configuration
Checking the Configuration
"Related Documentation"
"Using the ping Command to Verify
4-9