Checking The Configuration; Using Show Commands To Verify The New Interface Status - Cisco PA-POS-1OC3 Installation And Configuration Manual

Checking the Configuration

For more information on SONET APS, see the following documents:
•
•
Checking the Configuration
After configuring the new interface, use show commands to display the status of the new interface or all
interfaces, and use the ping and loopback commands to check connectivity. This section includes the
following subsections:
•
•
•
For complete command descriptions and examples, refer to the publications listed in the
Documentation" section on page

Using show Commands to Verify the New Interface Status

Table 4-5
and operating correctly and that the PA-POS-1OC3 appears in them correctly. Sample displays of the
output of selected show commands appear in the sections that follow.
The outputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Table 4-5 Using show commands
Command
show version or
show hardware
show diag slot
show interfaces pos
port-adapter-slot-number/interface port
number
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
4-12
Automatic Protection Switching of Packet-over-SONET Circuits at the following URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1824/products_feature_guide09186a0080087
ad9.html
Configuring Redundancy for POS/APS at the following URL:
http://www.cisco.com/warp/public/127/POS/pos-aps_14680.html
Using show Commands to Verify the New Interface Status, page 4-12
Using the ping Command to Verify Network Connectivity, page 4-22
Using loopback Commands, page 4-23
demonstrates how you can use the show commands to verify that new interfaces are configured
Function
Displays system hardware configuration,
the number of each interface type
installed, Cisco IOS software version,
names and sources of configuration files,
and boot images
Displays types of port adapters installed
in your system and information about a
specific port adapter slot, interface
processor slot, or chassis slot
Displays status information about the pos
interface in the Cisco 7200 VXR routers,
Cisco 7201 router, Cisco 7301 router, or
Cisco 7401ASR router
iv.
Chapter 4 Configuring the PA-POS-1OC3
"Related
Example
Router# show version
Router# show diag 2
Router# show interfaces pos 1/0
OL-6514-04