Figure 7-2 Bridging Ieee 802.1Q Vlans - Cisco ONS 15454 Software Feature And Configuration Manual

IEEE 802.1Q VLAN Configuration Example
Figure 7-2 Bridging IEEE 802.1Q VLANs
802.1.Q
Fast Ethernet 0.4
VLAN 4
Host station
VLAN 3
Host station
The following shows how to configure VLANs for IEEE 802.1Q VLAN encapsulation. Use this
configuration for both router A and router B. The example is shown in
bridge 1 protocol ieee
bridge 2 protocol ieee
bridge 3 protocol ieee
bridge 4 protocol ieee
!
!
interface FastEthernet0
no ip address
!
interface FastEthernet0.1
encapsulation dot1Q 1 native
bridge-group 1
!
interface FastEthernet0.2
encapsulation dot1Q 2
bridge-group 2
!
interface FastEthernet0.3
encapsulation dot1Q 3
bridge-group 3
!
interface FastEthernet0.4
encapsulation dot1Q 4
bridge-group 4
!
interface POS0
no ip address
crc 32
pos flag c2 1
!
interface POS0.1
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
7-4
POS 0
Native VLAN 1
Fast Ethernet 0.1
Fast Ethernet 0.2
Switch
VLAN 2
Host station
Fast Ethernet 0.3
POS 0
SONET/SDH
Fast Ethernet 0.4
VLAN 4
Host station
Chapter 7 Configuring VLANs
Native VLAN 1
802.1.Q
Fast Ethernet 0.1
Fast Ethernet 0.2
Switch
VLAN 2
Fast Ethernet 0.3
VLAN 3
Host station
Figure 7-2:
Host station
78-15224-02