Monitoring And Verifying Tunneling Status - Cisco ONS 15454 Software Feature And Configuration Manual

Chapter 8 Configuring IEEE 802.1Q and Layer 2 Protocol Tunneling
Command
Step 8
Router(config-if)# exit
Step 9
Router(config-if)# end
Step 10
Router# show dot1q-tunnel
Step 11
Router# copy running-config
startup-config

Monitoring and Verifying Tunneling Status

Table 8-2
Layer 2 protocol tunneling.
Table 8-2
Command
show dot1q-tunnel
show dot1q-tunnel interface interface-id
show l2protocol-tunnel
show vlan
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Purpose
Returns to global configuration mode.
Returns to privileged EXEC mode.
Displays the tunnel ports on the switch.
(Optional) Saves your entries in the configuration file.
shows the privileged EXEC commands for monitoring and maintaining IEEE 802.1Q and
Commands for Monitoring and Maintaining Tunneling
Configuring Layer 2 Protocol Tunneling
Purpose
Displays IEEE 802.1Q tunnel ports on the switch.
Verifies if a specific interface is a tunnel port.
Displays information about Layer 2 protocol
tunneling ports.
Displays IEEE 802.1Q tunnel information.
8-9