Understanding Ip Routing Protocols - Cisco ONS 15454 Software Feature And Configuration Manual

Configuring Networking Protocols
This chapter describes networking protocol configurations for the ML-Series cards. It provides initial
configuration information so you can get your ML-Series card up and running. For more information
about the Cisco IOS commands used in this chapter, refer to the Cisco IOS Command Reference
publication.
This chapter contains the following major sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
Complete the general interface configuration in the "Configuring Interfaces" chapter before proceeding
Note
with configuring networking and routing protocols.

Understanding IP Routing Protocols

This section describes how to configure the ML-Series card for supported IP routing protocols. It is
intended to provide enough information for a network administrator to get the protocols up and running.
However, this section does not provide in-depth configuration detail for each protocol. For detailed
information, refer to the Cisco IOS IP and IP Routing Configuration Guide and the Cisco IOS IP and IP
Routing Command Reference publications.
IP routing is enabled by default on the ML-Series card.
Cisco ONS 15454 SONET/SDH ML-Series Multilayer Ethernet Card Software Feature and Configuration Guide, R4.0
78-15224-02
Understanding IP Routing Protocols, page 10-1
Basic IP Routing Protocol Configuration, page 10-2
Configuring RIP, page 10-5
Configuring OSPF, page 10-9
Configuring EIGRP, page 10-21
Configuring BGP, page 10-28
Configuring IS-IS, page 10-31
Configuring Static Routes, page 10-32
Monitoring Static Routes, page 10-33
Monitoring and Maintaining the IP Network, page 10-34
Understanding IP Multicast Routing, page 10-35
Configuring IP Multicast Routing, page 10-36
Monitoring and Verifying IP Multicast Operation, page 10-36
C H A P T E R
10
10-1