Printing Takes Too Long - Xerox versalink C7020 User Manual

Troubleshooting
Probable Causes
The printer cable is disconnected.
There is a network-connectivity issue.
There is a wireless network setup or
connectivity issue.

Printing Takes Too Long

Probable Causes
The printer is set to a slower printing mode.
For example, the printer is set to print on
Heavyweight paper or Envelopes.
The printer is in Power Saver mode.
The way the printer was installed on the
network could be an issue.
The job is complex.
The print-quality mode in the driver is set to
Enhanced.
224 Xerox VersaLink
®
User Guide
Solutions
If the Status LED does not flash once after you send a print job,
check the connection between the printer and the computer.
If the printer is connected to a network:
Verify that the Wireless Network Adapter is installed and
properly configured. For details, refer to
Wireless Network
Solutions
It takes more time to print on certain types of special paper.
Ensure that the paper type is set properly in the print driver and
at the printer control panel. For details, refer to
page 276.
It takes time for printing to start when the printer is coming out
of Power Saver mode.
Determine if a print spooler or a computer sharing the printer is
buffering all print jobs and then spooling them to the printer.
Spooling can slow print speeds. To test the speed of the printer,
print some information pages such as the Demonstration Print.
For details, refer to
prints at the rated speed of the printer, there could be a
network or printer installation issue. For more help, contact the
system administrator.
Wait. No action needed.
Change the print-quality mode in the print driver to Standard.
C7020/C7025/C7030 Color Multifunction Printer
®
a.
Verify that the Ethernet cable is connected to the
printer.
b.
On the printer Ethernet connector, verify that the green
LED is On. If not, reseat both ends of the Ethernet cable.
c.
Examine the TCP/IP address in the Communication
section of the Configuration Report. For details, refer to
Printing the Configuration Report
d.
If the TCP/IP address is 0.0.0.0, the printer needs more
time to acquire an IP address from the DHCP server.
Wait 2 minutes, then print the Configuration Report
again.
e.
If the TCP/IP address is unchanged, or begins with 169,
contact your network administrator.
on page 49.
Information Pages
on page 45.
Connecting to a
Print Speed on
on page 44. If the page