KB Power On Password
The system will ask for a password. After entering correct pass-
word, the keyboard can then be used.
Hot Key Power On
When the power is on the "standby" mode, you can turn on the
power by pressing Ctrl+F1 or Ctrl+F2, Ctrl+F3...,according to the
choice you make in the BIOS.
The choices: Ctrl+F1, Ctrl+F2, Ctrl+F3...Ctrl+F12.
KBC Input Clock
The system designer must select the correct frequency for the
keyboard controller input clock. Do not change this value from the
default value.
The choices: 6MHz, 8MHz, 12MHz, 16MHz.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
an add-in FDC or the system has no floppy drive, select Disabled in
this field.
The choices: Disabled, Enabled.
Onboard Serial Ports (1, 2)
Normally, the boards' I/O chips will occupy a certain portion of
memory space. For each I/O device the computer provides an
I/O address. The more devices attached the more address needed
to organize the memory storage areas. If all the I/O devices were
run through the same address, your devices would come to a near
halt. Also the corresponding interrupt needs to be selected.
The choices: Disabled, 3F8/IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/
IRQ3, Auto.
56
GENE-6320 User Manual