CMOS Reset
This option is provided as a convenience for those who need to reset
the CMOS registers. It should always be set to "Normal" for standard
operation. If the CMOS needs to be reset, turn off the system, move
JP3 to 2-3, turn the system on, move jumper to 1-2 and press reset.
Table 1-1 CMOS Reset
Reset CMOS
JP3
* Manufacturer's Settings.
MicroATX Power Supply Enhancements
The Raptor MicroATX has a Power on mode selection. The jumper JP1
selects the power on mode.
Table 1-2 POWER ON Mode Select
Power on
mode
JP1
* Manufacturer's Settings.
SER C and SER D RS-232/RS-422/485 Selection
(Optional Feature)
To Select SER C and SER D operation mode use JP9. For RS-232
mode set 1-2, for RS-422/485 mode set 3-4. Both serial channels will
be changed by the same jumper, they cannot be selected independently.
Table 1-3 SER C and SER D RS-232/RS-422/485 Selection
SER C & SER D
Mode
JP9
*Manufacturer's Settings.
Chapter 1: Pre-Configuration
Normal
1-2*
Power on
immediately
1-2*
RS-232
1-2*
Clear CMOS
2-3
Power on upon
PWR_SW signal
(Button press)
2-3
RS-422/485
2-3
5