Loading New Or Saved Data To The Vps (Load) - Panasonic KX-TVP50E Installation Manual

SYSTEM MAINTENANCE AND TROUBLESHOOTING
- - - - - - SAVE Start!!
4.
Perform a Standard File Transfer. Set the data terminal to the receiving (Answer) mode
(Xmodem) and specify the backup filename. The specified data will be transmitted to the
data terminal.
Note
The data terminal used must be equipped with communications software that supports the
Xmodem file transfer protocol. The command can be cancelled by Typing [\] before entering
the receiving mode. Once the receiving mode has been selected, use the cancel command of
the communication software being used.
When you are finished saving files, Type [ONLN] at the $ prompt. This will turn on the
Answer Mode of the VPS (calls will be accepted again).

7.2.8 Loading New or Saved Data to the VPS (LOAD)

This command is used to install new data or to restore saved data to the VPS. The LOAD
command must be executed for each data file.
When performing this operation, always wait until the process completion indication appears
before proceeding.
1.
Type LOAD, then Press RETURN.
$ LOAD
VPS Flash Memory Data Load (PC -> VPS : Xmodem)
1: Program
2: Parameters
3: System Prompts
4. User Prompts-1
5. User Prompts-2
6. Custom Service Menus
7. Personal Greetings
8. Company Greetings
Select No.:=
2.
Select the item to be restored to the flash memory, then Press RETURN.
To start press 'RETURN'
3.
Press RETURN.
Start - - - - - - Load!!
When "CCC" appears, the VPS is ready for loading.
126 Installation Manual