Table of Contents
Advertisement
Parameter
Message
Waiting Lamp
Ports
Message
Waiting Lamp
for Every
Message
Max. Digits for
Callback No.
Callback No.
Entry Interdigit
Time-Out
System
Callback No.
Installation Manual
Value Range
(Default)
Port No.
Specifies the port numbers used for the Message Waiting
Notification Lamp feature.
(1, 2)
The VPS turns on the Message Waiting Lamp of the
extension using the port specified in this field. At least 1
port must be specified.
1. No
When set to "Yes," the VPS will turn on the Message
2. Yes
Waiting Lamp of the extension each time a new message
is recorded in the mailbox. This will occur even if the
(Yes)
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
When set to "No," the VPS will turn on the Message
Waiting Lamp for the first message only. The VPS will
not turn on the lamp for subsequent messages until the
Subscriber has accessed the VPS to retrieve the messages
stored there.
1-48 digits
Specifies the maximum number of digits the caller can
enter as a callback number. This number will be
(20)
displayed on beepers (pagers) if the "Beeper Callback
No. Entry Mode" is enabled.
1-10 s
Sets the maximum allowable time between each digit on
(5)
Beeper Callback No. Entry. If the caller does not enter
any digits within the specified time, the VPS will not
accept entry of any additional digits.
Up to 32 digits
Specifies a telephone number displayed on the
Subscriber's beeper (pager) as a callback number when
(None)
"Type" is set to "Beeper."
Note: If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the caller
will be displayed on the destination beeper (pager)
instead of the System Callback No. However, if the caller
fails to enter a callback number, the System Callback No.
will be displayed.
SYSTEM ADMINISTRATOR'S GUIDE
Table 61
Description/Function
235
Advertisement
Table of Contents
Troubleshooting
