Panasonic KX-TVP50E Installation Manual page 87

salesperson's mailbox to a different COS in the TVP50 and assign the paging group to that
COS. (This tells the VPS which paging group to dial). In the Intercom paging section, assign
the number "333" (KX-TA series) or "6303" (KX-TD series) to the paging group assigned
to the sales dept.
Fax Management (1 - 5 - 7 - 8)
Assigns up to 2 fax machines that can be extensions from the PBX. If the CNG tone is heard,
the KX-TVP50 will automatically forward the call to the first fax machine. If the first fax
machine is busy or doesn't answer (is out of paper), the call is forwarded to the second fax
machine. This also allows an extension to be assigned as the fax manager to be notified on
incoming faxes.
Disconnect Parameter (1 - 5 - 7 - 9)
Determines how many seconds of silence the KX-TVP50 allows during a caller's message
before disconnecting the call.
RS-232C Settings (1 - 6 - 1)
Allows the system administrator to change the baud, bit, etc.
Port Setting (1 - 6 - 2)
Only to be used if the KX-TVP50 is connected to a PBX other than a KX-T series PBX. Use
the CPC control of the telephone switch for normal disconnect problems.
Dialing Parameters (1 - 6 - 3 - 1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left alone. The one setting that is changed quite often is the Transfer
Sequence for the operator or the extension. By default it is set at FX on APT/DPT Integration
and FTX for Inband Integration. In other words, the voice processor dials the flash (recall),
waits for intercom tone and dials the extension number. By default the KX-TVP50 will stay on
the line to monitor the status of the call. If the extension user answers the voice processor will
announce "you have a call" prior to releasing the call. This can be alleviated by adding the
letter "A" or "D" to the sequence. "A" stands for answer; the call will be transferred without
the "you have a call" For a blind or unscreened transfer, add the letter "D" for disconnect.
Installation Manual
CUSTOMISING THE SYSTEM
87