Table of Contents
Advertisement
Enter the data using the following table as a guide.
Description
Dial Number
Type of
Device
Use Mode
No. of Retries
Busy Delay
Time
No Answer
Delay Time
Installation Manual
Value Range
(Default)
Up to 32 Digits of
[1-9,0, ,#,P,T,M,X]
(None)
1. Telephone
2. Beeper
(Telephone)
1. Not Use
2. Continuously
3. Scheduled
(Continuously)
0-4 Times
(0)
2-120 min
(3)
2-120 min
(30)
Table 24
Description/Function
Assigns the telephone or beeper (pager) number to
Device 1, 2 and/or 3.
P: Pause
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse,
or Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
The callback number entry code (X) must be entered
if COS is set to enable and set to beeper (pager).
Use backspace to delete your entry.
Assigns whether device is beeper (pager) or
telephone.
Specifies how Device 1, 2, or 3 is to be used. The
subscriber can also specify the use mode from his
telephone.
1. Not Use—Device 1, 2, or 3 is not used for a
notification call.
2. Continuously—Device 1, 2, or 3 is called whenever
a message is recorded in the mailbox.
3. Scheduled—Device 1, 2, or 3 is called on a
schedule basis when a message has been left in the
mailbox.
Specifies the number of times a device should be
retried when busy or no-answer.
The time the VPS will wait before retry on busy.
The time the VPS will wait before retry on No
Answer.
CUSTOMISING THE SYSTEM
103
Advertisement
Table of Contents
Troubleshooting
