INSTALLATION
2.8 TERMINAL CONNECTION
2.8.1 Requirements for Connecting Programming Terminal
The programming terminal must be connected with a serial cable with an RS-232C connector
at the RS-232C port. This must be a null modem cable. This enables system administration
(system setup, mailbox setup, and system diagnosis) to be performed.
Communication parameters of the VPS have been set to the following values at the factory:
COMMUNICATION PARAMETERS
Baud Rate:
Word Bit Length:
Parity:
Stop Bit Length:
2.8.2 Connecting the RS-232C Cable
RECOMMEND:
Before connecting the cable, make sure the power switches on both the data terminal and
the VPS are OFF.
Insert the RS-232C cable into the VPS with the connector indicating the same direction.
The cable must be shielded and no longer than 2 m.
38
Table 6
9600 bps
8 Bits
None
1 Bit
Installation Manual