Panasonic KX-TVP50E Installation Manual page 249

Parameter
Reconnect
Sequence on
Busy
Reconnect
Sequence on
No Answer
Reconnect
Sequence on
Refuse Call
Light-On
Sequence for
Message
Waiting Lamp
Light-Off
Sequence for
Message
Waiting Lamp
Call Waiting
Sequence
Release
Sequence for
Call Waiting
Inband Signaling Parameters
These parameters are used if the PBX sends touchtones to the VPS to indicate the state of a call
(busy, answered, disconnected, etc.). The integration Mode must be set to "Inband." If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
To select Inband Signaling Parameters, follow the menu path as shown:
System Administration Top Menu - 1 - 6 - 3 - 2
The following parameters can be programmed using "0-9", " ", "#", and "A-D."
Installation Manual
Value Range
(Default)
If an extension is busy, this sequence allows the VPS to
reconnect to the caller.
(F)
If the extension does not answer, this sequence allows the
VPS to reconnect with the caller.
(F)
This sequence is performed by the VPS to retrieve a call
(F) placed on hold after the extension (in the Call Screening
mode) has refused to accept it.
The dialling sequence that the VPS must perform to
enable the Message Waiting Lamp at an extension.
(None)
This is the dialling sequence that the VPS must perform to
disable the Message Waiting Lamp at an extension.
(None)
This sequence is carried out by the VPS when performing
(2)
call waiting if the extension being called is busy.
This sequence is performed by the VPS to release call
waiting.
(F)
SYSTEM ADMINISTRATOR'S GUIDE
Table 73
Description/Function
249