4.3.2.2
Set Pwr Key
The SET PWR button will displays the current output power and attenuation set points. Either
ALC or Manual power mode can be chosen. Press the SET PWR key while in the set power
screen to return to the main screen. Figure 4-3 shows the Set Pwr Screen.
4.3.2.3
Arrow Keys
The
/
/
UP
DOWN
RIGHT
change data fields. The key function is determined by the VFD display the operator currently in.
4.3.2.4
Enter Key
The ENTER key is mainly used enter menus and save data fields that have been changed using
the arrow keys.
4.4 Power-On and Checkout
Power on and check out should not be performed unless all procedures in the "Unpacking and
Installation" chapter have been completed. A qualified operator should only perform this task;
initial power-on is not a normal power-on sequence. Should a maladjustment be discovered
during initial power-on, go to "Maintenance and Troubleshooting" in the Indoor SSPA Service
Manual or contact CPI customer support (see Appendix A for the telephone number).
Initial power-on and check out consists of initial check, user preference settings, setting trip
limits, verify meter reading, and computer interface (CIF) configuration.
D
.01040053 R
.6
OC
EV
Figure 4-3. Set Pwr Screen
/
arrow keys are used to navigate menus, navigate data fields, and
LEFT
I
P
O
& C
NITIAL
OWER
N
HECKOUT
4-5