How To Configure Dhcpv6 Options Support - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 61 DHCPv6 Options Support

How to Configure DHCPv6 Options Support

•
•
•
•
•
Configuring the DHCPv6 Relay Agent
Command or Action
Step 1
Device> enable
Step 2
Device# configure terminal
Step 3
Device(config)# interface type number
Step 4
Device(config-if)# ipv6 dhcp relay
destination ipv6-address
[interface-type
interface-number]
Step 5
Device(config-if)# end
Configuring LDRA Functionality on a VLAN
Command or Action
Step 1
Device> enable
Step 2
Device# configure terminal
Step 3
Device(config)# ipv6 dhcp-ldra {enable
| disable | remote-id}
Step 4
Device(config)# vlan configuration
vlan-number
Configuring the DHCPv6 Relay Agent, page 61-5
Configuring LDRA Functionality on a VLAN, page 61-5
Configuring LDRA Functionality on an Interface, page 61-6
Verifying the LRDA Configuration, page 61-7
Verifying the LRDA Configuration, page 61-7
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.8.0E and IOS 15.2(4)E
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
•
Enters global configuration mode.
Configures an interface and enters interface configuration mode.
Specifies a destination address to which client packets are forwarded
and enables the DHCPv6 relay service on the interface.
Exits interface configuration mode and returns to privileged EXEC
mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Enables LDRA functionality globally.
You must enable the LDRA functionality in
Note
global configuration mode before configuring
it on an interface.
Specifies a VLAN number and enters VLAN configuration mode.
How to Configure DHCPv6 Options Support
61-5