Configuring Auto Identity At An Interface Level - Cisco Catalyst 4500 Series Software Configuration Manual

Configuration Examples for Auto Identity
Command or Action
Step 7
Switch(config-radius-server)# key ipv4
{0 string | 7 string} string
Step 8
Switch(config-radius-server)# end

Configuring Auto Identity at an Interface Level

When you configure two interface templates, you must configure the merge keyword. If you do not, the
last configured template is used.
Command or Action
Step 1
Switch# enable
Step 2
Switch# configure terminal
Step 3
Switch(config)# interface type number
Step 4
Switch(config-if)# source template
{AI_CLOSED_MODE | AI_LOW_IMPACT_MODE |
AI_MONITOR_MODE | template-name} [merge]
Step 5
Switch(config-if)# source template
{AI_CLOSED_MODE | AI_LOW_IMPACT_MODE |
AI_MONITOR_MODE | template-name} [merge]
Step 6
Switch(config-if)# switchport access vlan
vlan-id
Step 7
Switch(config-if)# switchport voice vlan
vlan-id
Step 8 Repeat Steps 4, 6, and 7 on all interfaces that
must have the Auto Identity feature configured.
Step 9
Switch(config-if)# end
Configuration Examples for Auto Identity
•
•
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
54-6
Example: Configuring Auto Identity Globally, page 54-7
Example: Configuring Auto Identity at an Interface Level, page 54-7
Purpose
Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server.
Note This command is not a part of the global template, and
you must configure it.
Exits RADIUS server configuration mode and returns to privileged
EXEC mode.
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
Enters global configuration mode.
Configures an interface and enters interface configuration mode.
Configures a source template for the interface.
(Optional) Configures a source template for the interface and
merges this template with the previously configured template.
When you configure two templates, if you do not configure
•
the merge keyword, the last configured template is used.
Sets the VLAN when the interface is in access mode.
Configures a voice VLAN on a multiple VLAN access port.
—
Exits interface configuration mode and returns to privileged
EXEC mode.
Chapter 54 Auto Identity