Power-On Self-Test Results - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 80 Performing Diagnostics
Detailed Status
---------------
. = Pass
L = Loopback failure
P = Port failure
E = SEEPROM failure
Ports 1
___________________________________________________________________________
Switch#

Power-On Self-Test Results

The following topics are discussed:
•
•
Sample Display of the POST on an Active Supervisor Engine
Examples include:
•
•
Supervisor Engine 7-E, Supervisor Engine 7L-E, and Supervisor Engine 8-E
Switch# show diagnostic result module 3 detail
Current bootup diagnostic level: minimal
module 3:
Overall Diagnostic Result for module 3 : PASS
Diagnostic level at card bootup: minimal
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
Power-On-Self-Test Results for ACTIVE Supervisor
prod: WS-X45-SUP7-E part: 73-12064-08 serial: CAT1450L1QU
Power-on-self-test for Module 3: WS-X45-SUP7-E
Test Status: (. = Pass, F = Fail, U = Untested)
U = Unknown
S = Stub failure
G = GBIC integrity check failure
2 3 4 5 6
. . . . . .
Sample Display of the POST on an Active Supervisor Engine, page 80-13
Sample Display of the POST on a Standby Supervisor Engine, page 80-16
Supervisor Engine 7-E, Supervisor Engine 7L-E, and Supervisor Engine 8-E, page 80-13
Supervisor Engine 6-E and Supervisor Engine 6L-E, page 80-15
SerialNo : CAT1450L1QU
1) supervisor-bootup ---------------> .
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test testing type ------> n/a
Last test execution time ----> Jul 21 2011 20:16:56
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Jul 21 2011 20:16:56
Total failure count ---------> 0
Consecutive failure count ---> 0
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
80-13