Configuring Other Tracking Characteristics - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 69 Configuring Enhanced Object Tracking
Command
group-number
Step 6
standby [
object-number [decrement
priority-decrement
[
Step 7
end
Step 8
show standby
Step 9
copy running-config
startup-config

Configuring Other Tracking Characteristics

You can also use the enhanced object tracking for tracking other characteristics.
•
•
•
•
Use the show track privileged EXEC command to verify enhanced object tracking configuration.
Configuring IP SLAs Object Tracking
Cisco IOS IP Service Level Agreements (IP SLAs) is a network performance measurement and
diagnostics tool that uses active monitoring by generating traffic to measure network performance. Cisco
IP SLAs operations collects real-time metrics that you can use for network troubleshooting, design, and
analysis.
For more information about Cisco IP SLAs on the switch, see
SLA Operations."
Release 12.4T.
Object tracking of IP SLAs operations allows clients to track the output from IP SLAs objects and use
this information to trigger an action. Every IP SLAs operation maintains an SNMP operation return-code
value, such as OK or OverThreshold, that can be interpreted by the tracking process. You can track two
Purpose
Configures HSRP to track an object and change the hot standby priority
] track
based on the state of the object.
]]
•
•
•
Returns to privileged EXEC mode.
Verifies the standby router IP address and tracking states.
(Optional) Saves your entries in the configuration file.
You can track the reachability of an IP route by using the track ip route reachability global
configuration command.
You can use the track ip route metric threshold global configuration command to determine if a
route is above or below threshold.
You can use the track resolution global configuration command to change the metric resolution
default values for routing protocols.
You can use the track timer tracking configuration command to configure the tracking process to
periodically poll tracked objects.
For IP SLAs command information see the Cisco IOS IP SLAs Command Reference,
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
(Optional) group-number—Enter the group number to which the
tracking applies.
object-number—Enter a number representing the object to be tracked.
The range is from 1 to 500; the default is 1.
(Optional) decrement priority-decrement—Specify the amount by
which the hot standby priority for the router is decremented (or
incremented) when the tracked object goes down (or comes back up).
The range is from 1 to 255; the default is 10.
Configuring Enhanced Object Tracking Features
Chapter 78, "Configuring Cisco IOS IP
69-9