Example: Configuring Auto Identity Globally - Cisco Catalyst 4500 Series Software Configuration Manual

Chapter 54 Auto Identity

Example: Configuring Auto Identity Globally

Switch> enable
Switch# configure terminal
Switch(config)# source template AI_GLOBAL_CONFIG_TEMPLATE
Switch(config)# aaa new-model
Switch(config)# radius server ISE
Switch(config-radius-server)# address ipv4 10.1.1.1
Switch(config-radius-server)# key ipv4 cisco
Switch(config-radius-server)# end
Example: Configuring Auto Identity at an Interface Level
Switch> enable
Switch# configure terminal
Switch(config)# interface gigabitethernet 1/0/1
Switch(config-if)# source template AI_CLOSED_MODE
Switch(config-if)# source template AI_MONITOR_MODE merge
Switch(config-if)# switchport access vlan 100
Switch(config-if)# switchport voice vlan 101
Switch(config-if)# end
Verifying Auto Identity
To verify the Auto Identity configuration, use the following commands:
The following output from the show template interface source built-in all command displays all the
configured built-in interface templates:
Switch# show template interface source built-in all
Template Name
Modified
Template Definition
dot1x pae authenticator
switchport mode access
mab
access-session closed
access-session port-control auto
service-policy type control subscriber AI_DOT1X_MAB_POLICIES
!
Template Name
Modified
Template Definition :
dot1x pae authenticator
switchport mode access
mab
access-session port-control auto
service-policy type control subscriber AI_DOT1X_MAB_POLICIES
ip access-group AI_PORT_ACL in
!
Template Name
Modified
Template Definition :
dot1x pae authenticator
switchport mode access
mab
: AI_CLOSED_MODE
: No
:
: AI_LOW_IMPACT_MODE
: No
: AI_MONITOR_MODE
: No
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
Verifying Auto Identity
54-7